
Specification
Touchscreen Parameter
Touch Screen Dimensions(mm) | External Dimensions | 426×347 |
Display Area | 386×307 | |
Glass Thickness | 6 | |
Ratio(Length Vs Width) | 4:3 | |
Material | Pure Glass | |
Light Transmission | 90% | |
Anti-Vandal | Impact Resistance: Strength can meet IEC60950 ball drop test (0.5 kg, 50 mm diameter ball dropped from height of 1.3 m) | |
Surface Hardness | Moh’s hardness rating of 7 | |
Electrical Parameter | ||
Voltage | +12VDC,normal (+11V to +13VDC) | |
Current | 60mA, typical, supply must be capable of sourcing, 250mA, minimum | |
Power | Average power consumption is 0.72W at +12VDC, | |
Noise parameter | Total noise and ripple requirement must be less than 50 mV (p-p) for frequencies above 1MHz | |
Interface | EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex Baud rate: 9600 | |
USB1.1 | ||
Touch Parameter | ||
Resolution | 4096×4096 | |
Conversion Time | Approximately 10.4 ms per coordinate set (including transmitting time) | |
Touch Activation Force | 80g | |
Environment Parameter | ||
Touchscreen | Controller | |
Operating Temperature | -20℃~+50℃ | 0℃~+65℃ |
Storage Temperature | -40℃~+70℃ | -20℃~+85℃ |
Operating Humidity | 40℃ at 90% RH, noncondensing | |
Operating Altitude | 3000m | |
Reliability | MTBF is greater than 300,000 hours per MIL-HDBK-217-F2 using the parts stress | |
calculation method for ground benign environment with an ambient temperature of 25℃ | ||
ESD | Per EN 61000-4-2: Contact discharge 4kV, air discharge 8kV | |
Flammability | The printed circuit board substrate is rated with 94V0 | |
ROHS | The Touch System including TouchScreen, Controller and Cable is ROHS compliant | |
Agency Approval | UL | |
Systems incorporating GT touchscreens, controllers, and cables have been approved for CE marking | ||
Systems incorporating GT touchscreens, controllers, and cables have been approved to FCC Class A compliance | ||
Controller Characteristic | ||
Type | The touchscreen controller of GeneralTouch Company is ST6001SU | |
Construction | Multi-layer surface-mount design with internal ground plane for EMI suppression | |
Dimensions | 85×62×12(mm) |